Dmx Connection; Connection Of A Dmx Controller - Renkforce LV-PT12 Bedienungsanleitung

• If you want to mount the device on a suitable traverse system, attach the effect light with the mounting bracket and
a suitable traverse clamp that is available separately.
• For this, install the effect light with the assembly bore of the mounting bracket to the traverse clamp and that in
turn to the traverse system. Use only assembly material suitable for the type of assembly and for bearing the effect
light load.
• The assembly must never swing freely.
• Additionally secure the installation with a suitable safety restraint cable or a safety net.
• The safety retention rope or the net must be designed to support the effect light in the event of failure of the main
support system independently of the main attachment.

9. DMX Connection

The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this case,
please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• Connect the port DMX IN (1) with the output of the DMX controller.
• The controller must have 7 free control channels.
• Connect DMX OUT (3) with the DMX input of the subsequent DMX device.
• Proceed accordingly with all other devices of the DMX chain.
• If the effect light is the last or the only device in the DMX chain, insert an XLR plug with a 120 ohm/0.25 W
terminating resistor into the DMX OUT (3) socket (between Pin2 and Pin3).
25