Handling; Troubleshooting - Renkforce LV-PT12 Bedienungsanleitung

13. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold to a warm
environment. The resulting condensation may destroy the device. Allow the device to reach room temperature
before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the intended
grip areas.
• Unplug the mains plug from the mains socket if you are not using the device for an extended period of time.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never put any filter foils, masks or other materials over the light exit. This may cause heat damage and danger of
fire.
• The device may heat up during operation. Never touch the casing during operation. Let the effect light cool off after
operation before touching or cleaning the casing.
• Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any objects
like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0.5 m around the device.
• The device is not suitable for continuous operation. Consistent compliance with operating breaks increases the
operational life span of the device. Let the device cool off for an extended period before taking it into operation
again.

14. Troubleshooting

By purchasing this effect light, you have acquired a product designed to the state of the art and operationally reliable.
Nevertheless, problems or errors may occur. Therefore, we would like to describe how to eliminate possible errors
here:
Always observe the safety information!
No function after the device has been connected to the power supply grid.
• The mains plug is not plugged into the socket correctly.
• The mains socket is not supplied with current.
There is no reaction to DMX commands.
• The blackout mode is activated at the DMX controller.
• The DMX address is set wrongly.
• The connection between the DMX controller and the effect light is interrupted.
• The DMX line is exposed to interferences. Try placing the DMX line away from the interference source.
• The polarity of the DMX connections to the DMX controller and effect lights are different.
• If possible, try another DMX controller.
32