JVC DT-V1710CG Bedienungsanleitung Seite 10

CONTROLS AND FEATURES
(INPUT CARD: OPTIONAL)
SDI INPUT CARD (IF-C01SDG)
SWITCHED
OUT
1
IN SDI 1
2
IN SDI 2
4
AUDIO 1
3
IN OUT
AUDIO 2
Compatible signal formats:
480/60i, 576/50i
HD SDI INPUT CARD (IF-C12HSDG)
Compliant with EMBEDDED AUDIO
E.AUDIO
HD SDI 1
IN
OUT
1
E.AUDIO
HD SDI 2
IN
2
OUT
Compatible signal formats:
720/60p, 1080/50i, 1080/60i, 1035/60i,
1080/24psF, EMBEDDED AUDIO
8
(cont'd)
SWITCHED OUT terminal
1
Output (OUT) terminal for the re-clocked signal. The input signal from SDI 1
or SDI 2 (selected with the INPUT SELECT buttons) is re-clocked and
output from this terminal.
NOTES:
• Even when the input signal is switched from the SDI Input Card, the SWITCHED
OUT terminal still outputs the SDI 1 or SDI 2 re-clocked signal (whichever you
selected last).
• No signal is output from the SWITCHED OUT terminal when the monitor is turned
off or in the stand-by mode.
D1 SDI signal input terminal (SDI 1, SDI 2)
2
Accepts an SMPTE259M compliant D1 SDI signal (component serial digital
signal).
Select SDI 1 input: press INPUT SELECT A (SLOT1)/C (SLOT2)/E (SLOT3) buttons.
Select SDI 2 input: press INPUT SELECT B (SLOT1)/D (SLOT2)/F (SLOT3) buttons.
NOTE:
Not compliant with EMBEDDED AUDIO.
3
Audio signal input/output terminals (for both SDI 1 and
SDI 2)
Input (IN) and output (OUT) terminals for the analogue audio signals.
• The IN and OUT terminals are bridge-connected.
4 Connection terminal
Attach to the connection terminal of your Multi-Format Monitor.
1 HD SDI signal input/output terminals (HD SDI 1, HD SDI 2)
Input (IN) and output (OUT) terminals for the HD SDI signal (HD
component serial digital signal)
This card is also compatible with EMBEDDED AUDIO signals with a 48 kHz
sampling frequency and channel range of 1 to 8 channels.
The EMBEDDED AUDIO output channel is controlled from this monitor.
Refer to "EMBEDDED AUDIO channel switch button" on page 4 for more
information.
Select HD SDI 1 input press INPUT SELECT A (SLOT1)/C (SLOT2)/E (SLOT3)
buttons.
Select HD SDI 2 input : press INPUT SELECT B (SLOT1)/D (SLOT2)/F (SLOT3)
buttons.
OUT terminal
The re-clocked HD SDI 1 and/or HD SDI 2 input signal is output from the
HD SDI 1 OUT and/or HD SDI 2 OUT terminal.
NOTE:
• Signals cannot be output from the OUT terminal when the monitor's power is OFF
or in the stand-by mode.
Connection terminal
2
Attach to the connection terminal of your Multi-Format Monitor.