Epson EMP-735 Installationshandbuch Seite 49

Connecting in Access Point Mode or Wired LAN Connection Mode
Basic
Projector name
ESSID
Password for
WEB control
Projector
keyword
DHCP
48
Enter a name for the projector. This name is used to identify
the projector when connected to the network.
Up to 16 single-byte alphanumeric characters can be entered.
Not displayed in the Wired LAN advanced settings screen.
Enter the ESSID. If the wireless LAN system used has an
ESSID, enter that value. The initial value is "EPSON."
Up to 16 single-byte alphanumeric characters can be entered.
When using EasyWeb, you will be asked to enter a password
when EMP Monitor is starting up. If a password has not been
setup, access can be made by simply pressing the computer
[Enter] key when the password entry screen is displayed.
Up to 8 single-byte alphanumeric characters are available.
If the projector keyword option is set to "ON", keyword entry
will be required when connecting to the projector over a
network. Use this function to prevent unintended or
unauthorized access to the projector during presentations, from
other points on the wireless LAN.
This option should normally be "ON".
Indicates DHCP use.
"ON": enables DHCP
"OFF": disables DHCP