I) "Inst": Installation/Assembly Function; J) "Offs": Offset Settings - Sygonix hx.1 38912X Bedienungsanleitung

i) "INST": Installation/Assembly Function

At initial commissioning, the display shows "INST" after the batter-
ies are inserted and the valve drive is run back so that the heater
actuator can be installed.
Proceed as follows if you need to start the installation/assembly
function again:
• Push the button "
• Use the buttons „
• Push the button "
• The valve drive in the heater actuator retracts all the way. Then
„INST" appears in the display.
Then proceed as described in chapter 8 for initial commission-
ing.
j) „OFFS": Offset Settings
Depending on the position of the heater actuator and the other
local situations,. you may need to increase or reduce the heating
output to achieve the desired room temperature.
Therefore, a specifi c offset can be set.
• Push the button "
• Use the buttons "
„OFFS".
• Push the button "
on the display.
• Set the desired offset temperature (-5 °C to +5 °C) with the but-
tons "
• Confi rm the setting with the button "
The temperature display in regular operation is not
changed by the offset setting!
44
The home technology brand for the entire house. More information at www.sygonix.com
" to call the function menu.
" to select the function „INST".
".
" to call the function menu.
" to select the function
". The offset temperature "0.0°" fl ashes
".
".