KEYS ON THE PSM-10
#14 ZOOM-keys
For zooming in and out. Using the zoom keys also
activated the auto iris. - see page 3 Auto Iris / Manual Iris.
#15 FOCUS-keys
When using the manual FOCUS-keys, the PSM-10
switches off the auto focus function.
Using the AF-key switches the auto focus on again.
#16 IRIS-keys
When using the manual IRIS-keys, the PSM-10 switches
off the auto iris function. The next time the ZOOM-keys are used
the auto iris is switched on again.
#17 WHITE-key
When the WHITE-key is pressed, the camera preforms an
one-push white balance - see page 4.
#18 AUTO FOCUS-key
Switches the auto focus on and off.
The AF light indicates, if the AF is switched on.
#19 MENU-key
Pressing this key for 1 second activates the on-screen menu
(see page 5).
#20 SELECT-keys
For navigating through the on-screen menu (see page 5).
#21 LASER POINTER-key
Important: Do not stare directly into the beam,
this would be bad for your eyes!
#22 PRESET-keys (programmable settings)
For storing a preset, press one of the PRESET-keys for more
than 2 seconds. For recalling a preset, press the PRESET-key
quickly. - see page 3
#23 FREEZE-key
To capture the current image. - see page 4
#24 POWER-key
INFRARED REMOTE CONTROL
Please note that an infrared remote control can only be used up
to a certain distance from the unit. Objects situated between the
PSM-10 and the infrared remote control, and weak batteries,
interfere with the reception. If the camera can only be controlled
from a close distance, or if it cannot be controlled at all with the
infrared remote control, you may have to change the batteries.
Open the cover on the back of the remote control by hand and
replace the two 1.5 V AA batteries with new ones.
Check the polarity of the batteries!
If you want to work with more than one PSM-10 in the same room,
the units should be set to different infrared codes, in order to
control them all individually.
To change the IR-code, enter the
C or D (code A is default). To change the IR-code on the remote control, simultaneously press PRESET
1, PRESET 2
(#22)
switches from A to B, C, D ... A ...etc. For resetting the remote control to code A simultaneously p
PRESET 1, PRESET 2 and ZOOM WIDE
on-screen menu, go to
and ZOOM TELE
(#14) - each time this key combination is used, the code
"Misc. Settings" and set the "IR Code" to A, B,
.
2
14 15
16
ZOOM
FOCUS
IRIS
WHITE
AF
17 18
TELE
PRESETS
1
FOCUS
15
AF
18
MEMORY
2
TELE
WIDE
PRESETS
1
2
3
FOCUS
IRIS
AF
WHITE
FREEZE
MEMORY
1
MENU
2
3
4
POWER
front
MENU
19
20
14
WIDE
21
2
3
22
IRIS
16
WHITE
FREEZE
17
23
1
19
MENU
3
4
20
POWER
24
-
+
X
X
+
-
back (open)
ress