Image Memory - WolfVision PSM-10 Bedienungsanleitung

4-IMAGE MEMORY

You can store 4 images and recall them by just pressing one of the numerical keys (#20) on the infrared
remote control:
Storing an image:
Recalling an image: Press one of the MEMORY-keys (#20) quickly
FREEZE
The current image can be captured by pressing the FREEZE-key (#23).
ON-SCREEN MENU SETTINGS
Color / Contrast Setting
Default is 1. For stronger contrast set to 0. For softer color-reproduction set to 2.
Detail
Also called "contrast-enhancement" or "aperture". Default is HIGH. MEDIUM makes the image
appearing softer. OFF disables the detail-function and outputs the data as seen from the CCD.
AF Region
Auto-Focus region can be switched between center (AF measures in the center area of the image) and
large (measures the complete image).
IR Code
Default is code A. If the IR-code is changed in the on-screen menu, the IR-code on the remote control
has also to be changed (see page 3).
Store Power-On-Preset
For storing the Power-On-Preset just adjust every function as required and this item.
Every time the camera is switched on the Power
Display Logo
Default is ON. If changed to OFF, the "WolfVision PSM-10"-logo is not displayed during power-up.
Mains-On
By default the camera switches on when the power source is connected. If Mains-On is set to Standby,
the camera enters the standby mode when it is connected to the power source.
Positive / Negative Mode
The output image of the Visualizers can be switched from positive to negative in the on-screen menu.
Black/White Mode
The output image of the Visualizers can be switched from color to black/white mode in the on-screen
menu.
Choosing the right output frequency
If you output the Visualizer image on a CRT-monitor or CRT-projector, use 75Hz-mode, because 60Hz
may show a slight image flickering. For LCD/DLP projectors or monitors and video conferencing units
60Hz is the best choice. If you are unsure which the best mode is, read the user manual of the
connected units.
Baudrate
The baudrate of the serial port can be set to 9600, 115200, 230400, 460800, 921600 baud/sec (9600
baud/sec are default).
Framerate
The Framerate can be set to 12, 15, 20, 25 or 30fps (30f/s are default).
Maximum Gain
With max. Gain the automatic gain (AGC) can be limited to a lower value to reduce noise (range: 0x096
to 0x3ff).
Image Rotation
The image can be rotated by 180°.
Press one of the MEMORY-keys (#20) for more than 2 seconds
-On-Preset will be performed.
4