Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EXTERNAL INFRARED (IR) SENSOR
POWER PLUG
+ 12V
GND
RS-232, SERIAL PORT
The serial port (#11) can be used to control the PSM-10 through an external device, like a remote
control system for a complete conference room and for image transfer with the camera control program
(the camera control program can be download from our homepage www.wolfvision.com/support).
1
2
3 4
5
6
7
8
9
9-pin D-Sub connector on unit
male (front side)
The complete serial protocol can be found on our internet homepage:
FIRMWARE UPGRADES
The software (firmware) of
update can be done via RS-232.
First download the latest firmware and WolfVision's Camera Control Software from Wolfvision's internet
homepage at www.wolfvision.com/support.
Then connect the PSM-10 to your computer and run the Camera Control Software. More details on the
firmware updates can be found on WolfVision's internet homepage.
For RS-232 connection, use a crossed serial RS-232 cable (Nullmodem-cable).
DC / REMOTE
A
L
M
U
B
K
N
T
C
O
S
P
R
H
D
E
G
F
VCC
IR-Data
GND
The connected power supply has to be approved to UL or CSA in accordance to
CSA 22.2-60950 or UL 1950 and the power supply output has to be LPS (limited
power source) rated.
Pins:
Baud rate: 9200, 19200, 38400, 57600,
databits: 8, stopbit: 1, parity: no
your PSM-10
can easily be upgraded to the latest version.
The PSM-10 can also be controlled via the DC/Remote connector. The
necessary connector is optionally available from your WolfVision dealer
(Connector for external control and power supply, 19 pin).
I
- see last page for more details
In some rooms the built-in IR-receiver may not be
enough. In this case connect the supplied external IR-
receiver to the IR-SENSOR plug (#12) and position the
IR-sensor somewhere on the ceiling (or in the room)
where users normally point the remote control at.
2: RX, 3: TX, 5: GND, 7: RTS, 8: CTS
921600
(selectable)
6
115200, 230400, 460800,
www.wolfvision.com/support
The firmware
Werbung
Inhaltsverzeichnis
