Infrared Remote Control - WolfVision VZ-C32 3 Bedienungsanleitungen

MAINTENANCE
release button
Exchanging Fuses
Disconnect the power cord (#11) before changing the fuses!
The fuses (#10) are situated behind a small lid at the power socket. It can easily be opened with a small
screwdriver etc.. Remove the socket, exchange the fuse(s) carefully, and put back the socket the right way
round into the socket holder.
The type of fuse is: F 1.5A. Do not use any other type !
Change the fuses for new ones and switch the unit on. If the fuse fails again contact your Visualizer dealer!
Cleaning
Cabinet: Clean the cabinet by gently wiping it with a soft, lint free cloth.
Glass: Clean the glass by gently wiping it with a soft, lint free cloth (do not use a paper tissue!). Clean by
breathing on the glass to create moisture then wipe with lint-free cloth (If not clean, use special
optical cleaner only!).
Never use strong cleaning agents such as acetone or benzene!
These substances can damage the surface and anti-reflex coating!
Please note that dust on the mirrors (#6, #7) inside the unit and the glass has only little effect on the picture
quality (as it is out of the focal range).
Opening the unit is reserved for WolfVision or authorized service personnel!

Infrared Remote Control

Please note that an infrared remote control can only be used up to a certain distance
from the unit. Objects situated between the Visualizer and the infrared remote control,
and weak batteries, interfere with reception.
If the Visualizer can only be controlled from a close distance, or if it cannot be
controlled at all with the infrared remote control, you may have to change the
batteries.
Open the cover on the back of the remote control and replace the two
1.5 V AA batteries with new ones.
Check the polarity of the batteries!
Recycle the batteries!
CAUTION!
Pinch Point!
To clean the mirror, the unit has to be opened!
The unit might be in need of adjustment after opening.
security lock
mechanism
WARNING:
17
IMPORTANT
-
+
X X
+
-
back (open)