Display Area "In Humidity" (Indoor Humidity); Setting And Activating/Deactivating Upper Indoor Humidity Alarm; Setting And Activating/Deactivating Lower Humidity Alarm - Eurochron 1530215 Bedienungsanleitung

i) Display Area „IN HUMIDITY" (indoor humidity)
The following setting and subfunctions are available:
• Setting and Activating/Deactivating Upper Humidity Alarm

• Setting and Activating/Deactivating Lower Humidity Alarm

• Displaying/Resetting Maximum Value Storage for Indoor Humidity
• Displaying/Resetting Minimum Value Storage for Indoor Humidity
Touch the display area „IN HUMIDITY" briefly repeatedly until the desired subfunction flashes.
„ Setting and Activating/Deactivating Upper Indoor Humidity Alarm
• Touch the display area „IN HUMIDITY" repeatedly until the indoor humidity and the display „HI AL" flashes.
• Select the upper threshold of the indoor humidity with the buttons „+" and „-". Keep the respective button pressed
for quick adjustment.
• Use the button „ON/OFF" to switch the alarm function on or off.
With the alarm function on, the icon „
ceeded, the weather station will emit an alarm. It is deactivated by touching the display in any location. The display
„HI AL" and the icon „
To get to the next subfunction (setting and activating/deactivating the lower humidity alarm) -> touch the
display area „IN HUMIDITY" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
„ Setting and Activating/Deactivating Lower Humidity Alarm
• Touch the display area „IN HUMIDITY" repeatedly until the indoor humidity and the display „LO AL" flashes.
• Select the lower threshold of the indoor humidity with the buttons „+" and „-". Keep the respective button pressed
for quick adjustment.
• Use the button „ON/OFF" to switch the alarm function on or off.
With the alarm function on, the icon „
dercut, the weather station will emit an alarm. It is deactivated by touching the display in any location. The display
„LO AL" and the icon „
To get to the next subfunction (displaying/resetting the maximum value storage for indoor humidity) ->
touch the display area „IN HUMIDITY" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
84
" appears below the display „HI AL". When the threshold value set is ex-
" continue to flash, however, until the measured value drops below the threshold value set.
" appears above the display „LO AL". When the threshold value set is un-
" continue to flash, however, until the measured value rises above the threshold value set.