Setting And Activating/Deactivating Upper Barometric Pressure Alarm; Setting And Activating/Deactivating Lower Barometric Pressure Alarm; Displaying/Resetting Maximum Value Storage For Barometric Pressure - Eurochron 1530215 Bedienungsanleitung

„ Setting and Activating/Deactivating Upper Barometric Pressure Alarm
• Touch the display area „PRESSURE" repeatedly until the barometric pressure value and the display „HI AL" flashes.
• Select the barometric pressure with the buttons „+" and „-". Keep the respective button pressed for quick adjust-
ment.
• Use the button „ON/OFF" to switch the alarm function on or off.
With the alarm function on, the icon „
ceeded, the weather station will emit an alarm. It is deactivated by touching the display in any location. The display
„HI AL" and the icon „
To get to the next subfunction (setting and activating/deactivating the lower barometric pressure alarm) ->
touch the display area „PRESSURE" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
„ Setting and Activating/Deactivating Lower Barometric Pressure Alarm
• Touch the display area „PRESSURE" repeatedly until the barometric pressure value and the display „LO AL"
flashes.
• Select the barometric pressure with the buttons „+" and „-". Keep the respective button pressed for quick adjust-
ment.
• Use the button „ON/OFF" to switch the alarm function on or off.
With the alarm function on, the icon „
dercut, the weather station will emit an alarm. It is deactivated by touching the display in any location. The display
„LO AL" and the icon „
To get to the next subfunction (displaying/resetting the maximum value storage for barometric pressure) ->
touch the display area „PRESSURE" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
„ Displaying/Resetting Maximum Value Storage for Barometric Pressure
• Touch the display area „PRESSURE" repeatedly until the maximum barometric pressure and the display „MAX" (to
the left of the weather symbols) flash.
• To reset the maximum value storage, keep the display area „PRESSURE" pushed for 3 seconds. The new maxi-
mum is the currently measured barometric pressure until it changes.
To get to the next subfunction (displaying/resetting the minimum value storage for barometric pressure) ->
touch the display area „PRESSURE" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
78
" appears below the display „HI AL". When the threshold value set is ex-
" continue to flash, however, until the measured value drops below the threshold value set.
" appears above the display „LO AL". When the threshold value set is un-
" continue to flash, however, until the measured value rises above the threshold value set.