K) Recording The Maximum And Minimum Values; L) Frost Alarm; M) Inside And Outside Heat Index - Renkforce 1208067 Bedienungsanleitung

• Keep the clock/set button (13) pressed to reach the setting mode.
• Press the + or - button (11 or 12) to correct the selection and the Clock/Set button to
confirm the setting in the sequence below (or to skip):
• Weather Forecast > 12/24hr format > D/M or M/D format > Time Zone Offset > Hr >
Min > Yr > > Month> Date > Temperature unit (degree C or degree F) > Rainfall unit >
Wind Speed unit > Pressure unit > Pressure value > EXIT
• (Weather Forecast > 12/24hr format > D/M or M/D format > Time Zone Offset > Hr >
Min > Yr > > Month> Date > Temperature unit (degree C or degree F) > Rainfall unit >
Wind Speed unit > Pressure unit > Pressure value > EXIT)
• PLEASE NOTE: The sensor of the outside temperature and humidity is installed in
the external sensor and set as channel 1. Additional or several thermo hygrometer
external sensors can be acquired separately and should be either set up as channel
2 or channel 3.

k) Recording the maximum and minimum values

• Press the Memory/-/Clear button (11) button again to display the maximum and
minimum values of temperature, humidity, heat index, dew point, wind speed and
wind chill.
• The corresponding
Memory/-/Clear button (11) in max/min mode pressed, to reset the saving of the
recordings.

l) Frost Alarm

• The symbol for the frost alarm
wind chill, if the outside temperature falls to or under 4 C
warning about possible icy road conditions is issued with this.

m) Inside and outside heat index

• The heat index connects the effects of heat and humidity. It specifies the discernible
temperature, how hot the heat-humidity-connection feels.
• Again press the Temp (3) button to display the inside and outside heat index on the
screen. The "HEAT INDEX" symbol appears.
64
"MAX" and "MIN"
appears on the display next to the display for
symbols appear.
with channel 1. Early
0
Keep the