VOLTCRAFT V-CHARGE 100 DUO Bedienungsanleitung Seite 92

• When the number of recognition processes for the delta-U charging procedure is to be
changed, briefly push the button "START/ENTER". The number flashes.
• Use the buttons "INC" and "DEC" to set the number of recognition process.
• Briefly push the "START/ENTER" button to confirm the setting. The display stops flashing.
• Start the rechargeable battery programme "RE-PEAK" by pushing the button "START/
ENTER" for 3 seconds.
If the settings are wrong, or if the charger detects a problem, a warning signal is emit-
ted and the appropriate information is shown in the display. You can stop the warning
signal by pressing the "BATT. TYPE/STOP" button. The charger then returns to the
previous configuration menu.
The display shows, e.g., the following data while charging:
The rechargeable battery type is shown in the upper
left ("NiMH" = NiMH rechargeable battery), the upper
middle shows the charging current and the upper right
the current rechargeable battery voltage.
The lower left shows the current rechargeable battery programme ("RPC" = "RE-PEAK"), the
middle the elapsed charging time and the charged capacity in mAh is displayed to the right of
this.
• Once the charging process has been completed, an audio signal is emitted (if it was not turned
off).
If you wish to cancel the charging process, push the "BATT. TYPE/STOP" button.
92
NiMH 0.2A
RPC 000:33 00017
9.59V