Calling Another Handset; Switching The Hands-Free Function On/Off; Setting The Speaker Volume - Topcom Butler 1410C Bedienungsanleitung

Butler 1410C

4.7.6. Calling another handset

This function only works if multiple handsets are subscribed to the base unit
station!
- Press the 'INT' key (softkey 3)
- The 2nd handset will only be automatically called if 2 handsets are
subscribed. If more than 2 handsets are subscribed:
• 'INT XXXXX' appears on the display. XXXXX are the numbers of the
handsets which can be called (e.g. 'INT-23--' only handset 2 and 3 can be
called).
• Dial the number of the handset you would like to call. Or press the
'BACK' key
- After finishing your call, press the Line key
handset back on the base unit.

4.8. Switching the hands-free function on/off

This function allows you to have a telephone conversation without holding the
receiver.
There are two ways of activating the hands-free function:
1. During a call:
- Press the Menu key during a call.
- 'HANDSFREE' appears on the display.
- Press the 'ON' key to activate the hands-free function or press 'BACK' to go
back.
- Press the 'OFF' key to switch off the hands-free function.
Caution: Using the hands-free function for a long time causes the battery to drain faster.
2. When the handset is placed in the charger:
- Press the Line key
hands-free mode. When you take the handset out of the charger, hands-free
mode automatically switches to normal calling.

4.9. Setting the speaker volume

Use the Volume key to set the volume of the speaker (handset).
You can choose from 3 levels: Volume 1, 2 and 3.
During a call, you can change the volume as follows:
- Repeatedly press the Volume key.
- The current volume level appears on the display.
(Softkey 1) to leave the menu.
and the telephone will automatically accept the call in
62 62 62 62
to hang up or put the