Selecting A Base Unit; Automatic Selection - Topcom Butler 1410C Bedienungsanleitung

Butler 1410C
4.16.7.1 Set/change emergency number:
- Repeatedly press the Menu key until 'TELEPHONE' appears.
- Press the OK key twice.
- 'HANDSET RING' appears on the display.
- Repeatedly press the Menu key until 'SET EMERGNCY' appears.
- Press 'OK' or 'BACK' to go back.
- Repeatedly press the Menu key until 'EDIT NR?' appears.
- Press 'OK' or 'BACK' to go back.
- Enter the number using the keyboard and use the '
number before the cursor
- Press the 'OK' key to confirm the number.
4.16.7.2 Activate emergency number
- Repeatedly press the Menu key until 'TELEPHONE' appears.
- Press the OK key twice.
- 'HANDSET RING' appears on the display.
- Repeatedly press the Menu key until 'SET EMERGNCY' appears.
- Press 'OK' or 'BACK' to go back.
- 'ENABLE?' appears.
- Press 'OK' to activate the emergency call facility or 'BACK' to go back.
When the emergency call facility has been activated, 'EMERGENCY' appears on
the display in standby mode.
4.16.7.3 Deactivating emergency call facility
- Press the left softkey
- Press the '*' key.
'EMERGENCY' disappears from the screen and the handset number is
displayed again.

4.17. Selecting a base unit

If your handset is subscribed to a number of base stations (max 4), you must
select a base unit because a handset can only communicate with one base unit
at a time. There are two possibilities:

4.17.1. Automatic selection

- Repeatedly press the Menu key until 'TELEPHONE' appears.
- Press the OK key twice.
- Repeatedly press the Menu key until 'SELECT BASE' appears.
- Press 'OK' or 'BACK' to go back.
.
68 68 68 68
<
' key to delete the