Tested Properties With Respect To Cleaning Agents; Cleaning Plan - Axis AKMH Betriebsanleitung

12.3.1 Tested properties with respect to cleaning agents

12.3.2 Cleaning plan

56 Kollmorgen | June 2015
The testing lab of ECOLAB Deutschland GmbH tested the resistance of the external
surfaces to the following industrial cleaning agents:
P3-topactive DES
l
P3-topax 12
l
P3-topax 56
l
P3-topax 66
l
P3-topax 990
l
In the process, the surfaces were immersed in the respective cleaning agent at 21°C
temperature for 28 days. This corresponds to approx. 2,500 cleaning cycles with 15-minute
contact each with the cleaning agent or 1,500 cleaning cycles with cleaning and subsequent
disinfection.Due to the possible relaxation after each treatment in practice the chemical
attack would be even lower.
Kollmorgen can only give a guarantee for the motor's lifecycle if the tested cleansing agents
are used. Any cleansing agent other than those mentioned above can be tested by
Kollmorgen upon request and, if appropriate, be approved.
Recommended cleaning plan (short form) with tested cleaning agents:
Flushing with water (40 °... 50 °C)
Flushing with low pressure. From top to bottom in the direction of the drain. Clean the drain.
Foam cleaning
Foaming from top to bottom.
Alkaline: P3-topax 66 (2-5%, 15 min daily)
Acid: P3-topax 56 (2%, if necessary 15 min)
Temperature: cold, up to 40 °C
Disinfection
Spraying with water (40 °... 50 °C) with low pressure. From top to bottom.
Spray disinfection: P3-topax 990 (1-2%, if necessary 30-60 min)
Foam disinfection: P3-topactiv DES (1-3%, if necessary 10-30 min)
AKMH Installation | 12 Technical Description