Prohibited Use; European Directives And Standards For The Machine Builder - Axis AKMH Betriebsanleitung

10.3 Prohibited use

10.4 European Directives and Standards for the machine builder

40 Kollmorgen | June 2015
The use of the AKMH motors is prohibited directly on mains supply networks.
l
AKMH motors should not be used in applications with continuous, direct contact with
l
food.
Standard AKMH cables are not sufficient for installation in food splash zones. When
l
applying in these applications, the tubing option for the cable is required.
Standard AKMH motors should not be applied in explosion-prone, hazardous
l
environments.
Standard AKMH motors should not be used in clean room applications.
l
AKMH motors should not be mounted vertically with shaft upwards to avoid harboring
l
dirt, soil, and liquids.
Commissioning the motor is prohibited if the machine in which it was installed
l
- does not meet the requirements of the EC Machinery Directive,
- does not comply with the EMC Directive,
- does not comply with the Low Voltage Directive.
Built-in holding brakes without further equipment must not be used to ensure functional
l
safety.
AKMH motors are components that are intended to be incorporated into electrical plant and
machines for industrial use. When the motors are built into machines or plant, the motor must
not be used until it has been established that the machine or equipment fulfills the
requirements of the
EC Machinery Directive (2006/42/EC)
l
EMC Directive (2014/30/EU)
l
EC Low Voltage Directive (2014/35/EU)
l
Standards to be applied for conformance with the EC Machinery Directive
(2006/42/EC)
DIN EN 60204-1 (Safety and Electrical Equipment in Machines)
l
DIN EN ISO 14159 (Safety of machinery - Hygiene requirements for the design of
l
machinery)
DIN EN 1672-2 (Food processing machinery - Hygiene requirements)
l
Kollmorgen AKMH motors meet these standards.
The machine manufacturer must check whether other standards or EC Directives must be
applied to the machine.
Standards to be applied for conformance with the EC Low Voltage Directive
(2014/35/EU)
IEC 60204-1 (Safety and Electrical Equipment in Machines)
l
IEC 60439-1 (Low-voltage switchgear and controller assemblies)
l
Standards to be applied for conformance with the EMC Directive (2014/30/EU)
IEC 61000-6-1 / 2 (Interference Immunity in Residential & Industrial Areas)
l
IEC 61000-6-3 / 4 (Interference Generation in Residential & Industrial Areas)
l
The manufacturer of the machine is responsible for ensuring that it meets the limits required
by the EMC regulations.
AKMH Installation | 10 Safety