Operation; Cleaning And Storing - Cleanmaxx Z 05107 - XL-312-80 Gebrauchsanleitung

Operation

CAUTION!
❐ Never hold the nozzles close to parts of your body or animals during use and do not
place your hands inside the nozzles. They could become stuck to the device/injured.
If the vacuum cleaner should become stuck, switch the device off immediately.
❐ Switch on the device only when you have checked that all the parts have been
properly attached and that the dust container and the dust fi lter are correctly inserted.
❐ On no account should the device be used to suck up the following:
– Liquids or wet substances (e.g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
1. Make sure that the accessories are correctly attached to the device (see the "Before
Initial Use" chapter, "Inserting / Removing the Handle Pole" section and the "Con-
necting the Nozzles" chapter).
2. Unwind the mains cable. To unwind the mains cable quickly, turn the upper cable
winder down and pull off the mains cable.
3. Insert the mains plug into a properly installed mains socket that is easily accessible.
4. Mount the desired nozzle on the main unit as described in the chapter "Connecting
the Nozzles".
5. Press the On / Off switch to switch on the vacuum cleaner.
6. Guide the nozzle over the surface to be cleaned.
7. Press the On / Off switch to switch off the vacuum cleaner.
8. If you have used the brush nozzle, move the device back into an upright standing
position, pull the mains plug out of the plug socket and wind the cable around the
cable winder.
9. If you have used the device as hand-held vacuum cleaner insert the handle pole
back into the device. Pull the mains plug out of the plug socket and wind the cable
around the cable winder.
10. To ensure optimum performance of the device, you should empty the dust container and
clean the dust fi lter regularly (see the "Cleaning the Device" chapter) after every use.

Cleaning and Storing

CAUTION!
❐ Empty the dust container if it is full and clean the HEPA fi lter regularly to prevent
overheating of the motor.
❐ Always remove the mains plug from the plug socket before doing any cleaning of
the device.
20