D) Display Of Minimum/Maximum Values; E) Deleting Minimum/Maximum Values; F) Selecting Temperature Alarm, Switching Alarm On/Off - Eurochron EFWS 91 i Bedienungsanleitung

d) Display of Minimum/Maximum Values

—
Briefly press the „" (11) or „" button (12) repeatedly until the display „
flashes.
—
If you are operating more than one outdoor sensor, select the corresponding
channel (1, 2 or 3) now with the „channel" (15) button.
—
Press the „mem" button (17) briefly; the display shows the minimum values for
indoor/outdoor temperature; „MIN" is displayed additionally.
—
Press the „mem" button (17) briefly; the display shows the maximum values for
indoor/outdoor temperature; „MAX" is displayed additionally.
—
Press the button „mem" (17) again to return to display of the current measured
values.

e) Deleting Minimum/Maximum Values

—
Briefly press the „" (11) or „" button (12) repeatedly until the display „
flashes.
—
Hold the „mem" button (17) for about 3 seconds. The minimum and maximum
values are then deleted.
The new maximum and minimum values stored are the current measured
values, until they are changed again.

f) Selecting Temperature Alarm, Switching Alarm On/Off

An upper and lower temperature range can be set for each of the 3 channels and an
alarm signal can be emitted when the values leaves the range.
—
Briefly press the „" (11) or „" button (12) repeatedly until the display „
flashes.
—
Select the desired outdoor sensor with the button „channel" (15).
—
Repeatedly press the „alarm" button (14) briefly to switch between the upper
temperature limit (icon „ "), lower temperature limit (icon „ ") and normal
display.
—
When the „ " or „ " icons are displayed, the respective temperature alarm
can be switched on or off by briefly pressing the „" (11) or „" (12) buttons.
If the temperature alarm is switched off, „OFF" is displayed.
If the temperature alarm is activated, a temperature value is displayed.
When the alarm tone is emitted (e.g. if you have set +30.0 °C as the upper
temperature limit and the measured value exceeds this limit), the alarm tone can
be stopped by briefly pressing the „alarm" button (14).
"
"
"
61