B) Weather Station - Eurochron EFWS 91 i Bedienungsanleitung

b) Weather Station

—
Open the battery compartment (16) on the weather station's rear by pushing
the battery compartment lid downwards a bit so that it can be taken off.
—
Then insert two batteries of the type AAA/micro into the battery compartment
of the weather station with correct polarity (observe plus/+ and minus/-).
—
Close the battery compartment again.
—
After inserting the batteries, the display briefly shows all display segments.
—
Then the receiver icon flashes on the left of the display (3).
The weather station is now scanning for the outdoor sensor signal. If no outdoor
sensor is recognised (e.g. because no batteries are inserted yet), you may start
the search manually later, see chapter 11.
—
After completion of the sensor search, the receiver display (8) for the DCF signal
in the display flashes. Depending on receiver strength of the DCF signal, more
circles will be visible.
Low signal
Place the weather station, e.g., close to a window. Maintain a distance of at
least 1 m to other electronic devices (TV, computer, phone) and metal parts
(e.g. radiator).
A bad reception can also be caused by, e.g. metallised insulated glass,
reinforced concrete construction design, coated special wallpaper or an
installation in cellars.
If a good reception position was found, do not move the weather station
during that time. Do not push any buttons on the weather station.
Recognition of the DCF signal and its assessment may take a few minutes.
For more information about DCF reception, see chapter 10.
-> strong signal
49