B) Switching Dcf Reception Off And On, Starting Dcf Search - Eurochron EFWS 91 i Bedienungsanleitung

If no correct time is displayed at initial commissioning even after more than 10
minutes due to reception problems, start a new reception attempt. Proceed as
described in chapter 10. b).
For more information on what to observe when selecting the site of setup
for the weather station, see chapters „16. Troubleshooting" and „17. Range";
they also offer information on what to try to achieve perfect DCF signal
reception.
If no DCF reception is possible at the weather station setup site, set the
time and date manually; see chapter 12. a).

b) Switching DCF Reception Off and On, Starting DCF Search

keep the button „" (11) pressed for about 3 seconds to switch the DCF reception
on or off.
—
After switching off, the receiver display (8) for the DCF signal disappears.
—
When the DCF signal is switched on, the weather station scans for the DCF
signal. Depending on receiver strength of the DCF signal, more circles will be
visible.
Low signal -> strong signal
Recognition of the DCF signal and its assessment may take a few minutes.
Do not move the weather station during this time and do not press any button.
If no DCF reception is possible at the weather station setup site, set the
time and date manually; see chapter 12. a).
52