Checks And Tasks Before First Operation - Zipper ZI-RAM80V Betriebsanleitung

12.3

Checks and tasks before first operation

Read, understand, follow security and setup information

Check all fixing nuts and screws of the machine if tightened well! Not entirely tight-

ened nuts and screws might become even looser and be lost due to the vibration dur-
ing operation
Fill up motor oil!

Unfasten and remove oil dipstick.
o
Check the oil level – it should reach at least the
o
lower edge of the neck.
If the oil level is too low fill it up with SAE15W40
o
motor oil.
Fill up oil (viscosity: 140) in tamping assembly!

o Check the oil level and if necessary top up to the mark
A too low oil level leads to engine damages.
Please understand that we do not accept any reclamations on
engine damage being caused by insufficient oil level.
The handling costs of claimed guarantee of defect engines that
during service check turn out to be caused by an insufficient oil
level will be charged to the customer entirely.
Check fuel level

The ZI-RAM80V is being powered with petrol (min. octane 91)
o
Pay attention to all security regulations in connection with fuel.
o
Remove fuel tank cap, check fuel level by sight.
o
If refueling is necessary, pay attention to all security regulations regarding re-
o
fueling, refuel only with filter.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Vibrationsstampfer / Vibrating tamper / Pison vibrador / Pilonneuse
ATTENTION!
ZI-RAM80Vite 27
SETUP
Seite 27