Rotax 125 MAX evo Betriebsanleitung Seite 78

ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
 Install intake silencer tube (pos. 2) in a vertical position in the bottom half of intake
silencer case (pos. 1) so that the rounded intake openings point outwards.
 Note:
Gentle heating of the intake silencer simplifies the installation.
 Fit the carburetor socket (pos. 6) into the top half of intake silencer case (pos. 5) so
that the arrow on the socket points towards the carburetor.

Install the filter element (pos. 4) with holders (pos. 3) into the bottom half of
intake silencer case (pos. 1).
 Assemble bottom half of intake silencer case (pos. 1) with top half (pos. 5) as shown
in following illustration. Make sure that the locking is interlocked properly.

Attach the intake silencer with the supplied hose clamp (pos. 11) on the carburetor.
 Note: The carburetor socket (pos. 6) is asymmetrical and can be turned so that the best
possible position between carburetor and intake silencer can be achieved.
 Attach the intake silencer on the support bracket (pos. 8) using 2 Allen screws
M6x20 (pos. 10) with washers (pos. 9) and nuts (pos. 7).
Page 25/53
K00432 / Fig. 42
Edition 07/2016