Preparing And Installing The Aquaclean Filter; Activating The Aquaclean Filter - Saeco Incanto HD8911 Bedienungsanleitung

English
14

Preparing and installing the AquaClean filter

Activating the AquaClean filter

AQUA CLEAN
FILTER
0 / 8
brewed more than 50 cups (with 100 ml capacity), you need to descale the
machine before you activate the filter.
Note: Replace the AquaClean filter as soon as the capacity has dropped to
0% and the filter icon flashes quickly. Replace the AquaClean filter at least
every 3 months, even if the machine has has not yet indicated that
replacement is required.
Tip: We advise you to buy a new filter when the capacity has dropped to
10% and the filter icon starts flashing slowly. This ensures that you can
replace the filter when the capacity has dropped to 0%.
1 Remove the AquaClean filter from its packaging. Shake the filter for about
5 seconds.
2 Immerse the AquaClean filter upside down in a jug with cold water and
wait until no more air bubbles come out.
3 Insert the AquaClean filter vertically onto the filter connection. Push the
AquaClean filter to the lowest possible point. Make sure that the filter fits
tightly and the seal is in the right position, to guarantee the best
performance.
You can install the AquaClean filter at first installation as part of the
installation procedure. If you skipped installation of the AquaClean filter at
first use, you can install it by entering the menu as described below.
1 Press the MENU button, scroll to 'AquaClean' filter and press the OK
button to confirm.
-
The display shows the number of AquaClean filters that have been
installed previously from 0 to 8 filters.