Kinax 3W2 Mit - Camille Bauer KINAX SR 709 Betriebsanleitung

Contents
1. Read first and then ... .................................................................................. 1
2. Brief description ........................................................................................... 1
3. Scope of supply ........................................................................................... 1
4. Specification and ordering information ........................................................ 2
5. Technical data ............................................................................................. 2
6. Mounting ...................................................................................................... 3
7. Electrical connections .................................................................................. 3
8. Setting the beginning and end of the measuring range .............................. 4
9. Adaptation from 2-wire connection to
3- or 4-wire connection and vice versa ....................................................... 4
10. Reversing the rotation
for instruments with measuring ranges > 150
11. Dimensional drawings .................................................................................. 4
Safety precautions to be strictly
observed are marked with following
symbols in the Operating Instructions:
1. Read first and then ...
The proper and safe operation of the device assumes that the
Operating Instructions are read carefully and the safety warn-
ings given in the various Sections
6. Mounting
7. Electrical connections
are observed.
Unauthorized repair or alteration of the unit invalidates the
warranty!
The device should only be handled by appropriately trained
personnel who are familiar with it and authorised to work in
control technique installations.
2. Brief description
The KINAX 3W2 transmitter converts the angular position of a shaft into a load
independent direct current signal, proportional to the angular position.
Explosion-proof "Intrinsically safe EEx ia IIC T6" versions with I.S. measuring
output rounds off this series of transmitters.
Operating Instructions
Camille Bauer LTD
Aargauerstrasse 7
CH-5610 Wohlen/Switzerland
Phone +41 56 618 21 11
Fax +41 56 618 35 35
e-mail: info@camillebauer.com
http://www.camillebauer.com
3. Scopy of supply
Transmitter, one of the six versions (Fig. 1)
3 clamps (Fig. 2)
1 ea. Operating Instructions (Fig. 3) in English, French, German
1 Ex approval (Fig. 3), only for Ex version devices
° ....................................... 4
Fig. 1
Fig. 2
1
KINAX 3W2 with
standard drive shaft
at front only,
∅ 2 mm, length 6 mm.
KINAX 3W2 with
special drive shaft
at front only,
∅ 6 mm, length 12 mm.
KINAX 3W2 with
special drive shaft
at front only,
∅ 1/4˝, length 12 mm.
Fig. 3
Transmitter
for angular position
KINAX 3W2
57-3W2 Be 997 223 01.06
KINAX 3W2 with special drive
shaft at front and at rear.
At front: ∅ 2 mm, length 12 mm.
At rear: ∅ 2 mm, length 6 mm.
KINAX 3W2 with special drive
shaft at front and at rear.
At front: ∅ 6 mm, length 12 mm.
At rear: ∅ 2 mm, length 6 mm.
KINAX 3W2 with special drive
shaft at front and at rear.
At front: ∅ 1/4˝, length 12 mm.
At rear: ∅ 2 mm, length 6 mm.