Error And Information Messages - Futurelight Scan SC - 980 Bedienungsanleitung

DMX
Channel
Function
7 8
COLOURS COLOURS
EFFECTS
1 2
Standard Standard
protocol protocol
This message appears if you try to switch On the lamp within 5 minutes after having switched it Off (the lamp is
too hot). The message will come at the display if the lamp doesn´t ignite within 20 seconds. The SC-980 will
store this information and automatically ignite the lamp when the 5 minutes period has expired.
The ignition of the lamp is seven times unsuccessful (six times were appeared HEAt (message before), on the
display will appear "LAEr", meaning that the lamp could be damaged or even missed, the fixture is overheating
(can be occured if the ambient temperature is 55°C or more) or there could be a failure on the ignitor or ballast.
Please place or replace the lamp, check the ambient temperature or if the situation was not caused by the lamp
please, contact your dealer.
This messsage inform you that the main PCB does not communicate correctly with the control board.
(color wheel 1 error) This messsage will appear after the reset of the fixture if the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main
PCB). The color wheel is not after the reset in the default position.
(color wheel 2 error) This messsage will appear after the reset of the fixture if the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main
PCB). The color wheel is not after the reset in the default position.
(static gobo wheel error) This messsage will appear after the reset of the fixture if the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main
PCB). The rotating gobo wheel is not after the reset in the default position.
This error message inform you that the fixture was overheating (occured if the ambient temperature is 55°C or
more) and that the relay switched Off the lamp. This message will shine on the display until the temperature will
be on the suitable level, then on the display will appear the HEAt message meaning the lamp is too hot. (explanation
see above).
This message appears if the lamp lighting sensor is failed. Please, contact your dealer.
This message will appear if the fixture was shortly disconnect from the main.
It will appear if the frequency of the main is not standard 50 or 60Hz.
1 2
COL. 1 COL. 2
Calibration Calibration
0 - 255 0 - 255
Smooth microstep movement
9 10
STATIC ROTATING
GOBOS GOBOS
Standard Standard Standard
protocol protocol protocol

8. Error and Information messages

3 4
EFEC. SGOB
Calibration Calibration
0 - 255 0 - 255
11 12 13
GOBO
IRIS
ROTATION
Standard Standard
protocol protocol
34
5 6
RGOB -
Calibration
0 - 255
14 15
FOCUS STROBO
Standard Standard
protocol protocol
16
DIMMER
Standard
protocol