Safety; Safety Instructions; General Instructions; Introduction - Futurelight Scan SC - 980 Bedienungsanleitung

FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY

1.1 Safety instructions

This device has left our premises in absolutely perfect condition. In order to maintain this condition and to ensure
a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written
in this manual. The manufacturer will not accept liability for any resulting damages caused by the non-observance
of this manual or any unauthorized modification to the device.
a dangerous electric shock when touching the wires !
This device falls under protection class I. Therefore it is essential to connect the yellow / green conductor to
earth.
The electric connection must be carried out by a qualified employee.
Do not connect this device to a dimmer pack.
For replacement use lamps and fuses of same type and rating only.

1.2 General instructions

Please do never run the device without lamp!
Use this projectors in closed rooms only.
Do not shake this device. Avoid brute force during operational actions.
For safety reasons unauthorized modifications to the device are forbidden.
You can install this projector at any desired place - as long as you follow the given instructions. Ensure that the
structure to which you attach the projector is secure.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation water might damage your device. Leave the device switched off until it
has reached room temperature.
When taking the device into operation, please make sure that the housing is closed firmly with all the necessary
screws tightened up.
Thank you for having chosen a FUTURELIGHT SC-980. You acquired a versatile, powerful and intelligent
lighting-effect.
Unpack your FUTURELIGHT SC-980 and make sure that there are no damages caused by transportation.
Should there be any, please consult your local dealer and do not take the device into operation.

2.1 Fitting the lamp

Install the lamps with the device switched off only.
To insert the lamp (HMI/MSI 1200 W) open the housing by loosening the fastening screws at the side panels and
frontcover.
Do not install a lamp with a wattage! A lamp like this generates temperatures the device is not designed for.
Keep this device away from rain and moisture !
Unplug mains lead before opening the housing !
BEFORE YOU INITIAL START - UP!
Caution ! Be careful with your operations.
With a voltage of 230 V you can suffer
CAUTION ! EYEDAMAGES !
Avoid looking directly into the light source
(meant especially for epileptics) !

2. Introduction

Unplug from mains before !
CAUTION !

1. Safety

DANGER !
22