Installation; General Instructions; Danger Of Fire; Connection To The Mains - Futurelight Scan SC - 980 Bedienungsanleitung

3. Installation

3.1 General instructions

DANGER OF FIRE !

When installing the device, make sure there is no highly inflammable
material (decoration articles, etc.) in between a distance of min. 0,5 m.
The projectors can be installed in any position without altering its operation characteristics.
Make sure that the device is fixed properly ! Ensure that the structure
to which you are attaching the projectors is secure
For fixing the projectors use the hole provided in the bracket. The hole in the adjustable mounting bracket has a
diameter of 10 mm.
For overhead use, fit a safety chain or cord.

3.2 Connection to the mains

Connect the projector to the mains with the enclosed power-plug.

3.3 DMX-512 connection / connection between projectors

Connect the controller to the projector or one projector to another only by a stereo shielded cable and 3-pin XLR-
plugs.
Caution: At the last scanner, the DMX-cable has to be terminated with a 120 resistor. Solder the resistance
W
into a 3-pin XLR-plug and plug it in the DMX output of the last scanner.
The wires must not come into contact with each other, otherwise
the projectors will not work at all, or will not work properly.

4. Setup

4.1 Function of the control channels - 16 bit protocol

4.1.1 Channel 1 - Pan
Push slider up in order to move mirror horizontally (PAN).
Gradual mirror adjustment from one end of the slider to the
other (0-255, 128-center). The mirror can be stopped at any
position you wish.
25