Futurelight Scan SC - 980 Bedienungsanleitung Seite 33

- Adjusting the default positions of colour, gobo and effect wheels
By this function you can calibrate and adjust the colour, gobo and effect wheels to their standard/right positions.
Use the [Up] and [Down] keys to browse through the adjusting menu - the display shows step by step these
messages: "PAn, Tilt, SPEd, Col1, Col2, EFEC, SGob, rGob, Grot, IriS, FoC, Stro, dinr" by which you can
adjust the fixture to the required / desired position (0-255) before the function calibration. Then when the positioning
is finished use the last "FCAL" function (Fixture calibration).
1. Calibration via the control board
Press [Enter] and on the display will apper by using [Up] and [Down] keys these messages: "Col1, Col2, EFEC,
SGob, rGob" for their very smooth function calibration. Select one of them press [Enter] and use the [Up] and
[Down] keys in order to adjust their right value from 0-255 Then press [Enter] to confirm or [Mode] to cancel and
return to the menu. This can be repeated for each calibration parametr if it is required. When the calibration
works are finished it is necessary to use the "ArES" function in order to write the calibration values to the
memory (EEPROM) and to make a reset in order to check the new adjusted positions of the colour, gobo and
effect wheels. When the reset of the fixture is finished on the display will appear the "FCAL" message. Press
[Enter] to repeat the calibration or [Mode] to return to the "AdJ" menu.
2. Calibration via the external controller
Press [Enter] and on the display will apper by using [Up] and [Down] keys these messages: "Col1, Col2, EFEC,
SGob, rGob" - calibration parameters. Select one of them and press [Enter].
Now you can calibrate the colour, gobo and effect wheel by your controller. The DMX calibration protocol is
described in the table mentioned below.
DMX Calibration protocol:
After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and return to the menu
without reset by the "ArES" function) and use the "ArES" function in order to write the calibration values to the
memory (EEPROM) and to make a reset in order to check the new adjusted positions of the colour, gobo, effect
and rot. gobo wheels and gobo indexing.
Personality Display
Pan reverse
Tilt reverse
Movement
resolution
Lamp on
automatically
Automatic black-
-out of display
Display intensity
Lamp Off via DMX
Low fan speed
operating
Default values
(SHADED)
33