Futurelight Scan SC - 980 Bedienungsanleitung Seite 32

- Automatic blackout of Display
This function allows you to keep the display On or to turn Off automatically 2 minutes after last pressing any key
on the control board. Use the [Up] and [Down] keys to select "On" if you wish to keep the display On or "Off" if
you wish to turn Off automatically 2 minutes after last pressing any key on the control board and press [Enter] to
confirm or [Mode] to cancel and return to the menu.
- Display intensity
By this function you can adjust from 20 to 100 the intensity of the display. Use the [Up] and [Down] keys to select
the level of the display intensity and press [Enter] to confirm or [Mode] to cancel and return to the menu.
- Lamp Off via DMX
This function allows you to switch Off the lamp by DMX. Use the [Up] and [Down] keys to select "On" if you want
to switch Off the lamp by DMX or "Off" if you don't want to switch Off the lamp by DMX and press [Enter] to
confirm or [Mode] to cancel and return to the menu.
- Temperature
Temperature readouts of fixture inside in Celsius. Inside temperatures below 80° C are not critical. 80° C and
more lead to the lamp being switched off. Please note that the outside temperature should not exceed 55° C.
- Low fan speed operating
By using this function you can choose 3 types of low fan speed operating. Browse through this menu by the
pressing [Up] and [Down] keys - the display shows step by step these messages: "reG, Lo.HI, Lo.OF". Press
[Enter] if you wish to select one of them or [Mode] to cancel and return to the menu.
- continuous controlling of the fan speed
the fan automatically raises its speed in order to control inside temperature of the lighting,
if the temperature inside increases about certain level (the low fan speed reduces the cooling of
the lighting). This cycle can repeat several times until the temperature inside is on suitable level.
- low/high speed of the fan operating
the fan keeps the adjusted low speed until the temperature exceeds max. inside temp..of the
fixture, then the SC-980 automatically switch from low to high the fan speed.
- low speed / Switch Off the lamp operating
the fan keeps the adjusted low speed until the temperature exceeds max. inside temp.. then the
SC-980 automatically switch Off the lamp.
- Default settings
Press [Enter] to reset all fixture personalities (not the adjusting functions) to the default values. On the display
will appear „rSt" meaning that the fixture makes the reset. See the table of personality setting and their default
positions.
32