Remotely Controllable Functions; Lamp; Switching On And Off The Lamp By Control Board; Colour Wheels - Futurelight Scan SC - 980 Bedienungsanleitung

This situation can be occurred if:
there is not connected the 3 PIN XLR plug (cable with DMX signal from controller) in the input of the SC-980
the controller is switch Off or is failed the cable or connector is failed or the signal wires are swap in the input
connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to ensure
proper transmission on the DMX data link.

6.1 Lamp

The SC-980 is run with a HMI/MSI 1200W lamp.
A relay inside of the SC-980 allows you to switch On and Off the lamp via itself control board on the top side or
via your controller without affecting the rest of the lighting.

6.2 Switching On and Off the lamp by control board

1. Switch On the SC-980 and wait until the fixture reset has finished.
2. Press the [Mode] key in order to access the main menu. Browse through the menu by pressing the [Up] and
[Down] keys until the display shows "LAMP". Confirm by pressing [Enter] key.
3. Use the [Up] and [Down] keys to select "On" for switch On the lamp and "Off" for switch Off the lamp and
press [Enter] to confirm or [Mode] to cancel.
Note:
It is also important to note, that the discharge lamp is cold restrike types, that means, that it has to be cold before
re-striking. For this reason, you have to wait 5 minutes (max. speed of fan must be adjusted) after having
switched Off the lamp before you can switch it back On again. If you try to switch On the lamp within 5 minutes
after having switched it Off, the SC-980 will store this information and automatically ignite the lamp when the 5
minutes period has expired. The message "HEAt" will appear on the control board display at the back side of
the SC-980. If the ignition of the lamp is seven times unsuccessful, on the display will appear "LA.Er", meaning
that the lamp could be damaged or even missed, or there could be a failure on the ignitor or ballast.

6.3 Colour wheels

The SC-980 has two colours wheels both with 9 color positions - 8 of these with dichroic colors and the last one
open. The wheel can be positioned between two adjacent colors in any position. It is also possible to rotate the
color wheel 1 continuously at different speeds „Rainbow effect". Hot and cold colour temperature filters (3200 K
and 5600 K) are situated on the colour wheel 2.
By color macro function it is possible to obtain 64 different colours in following order: white, pink, magenta, red,
orange, yellow, green, cyan, blue, UV

6.4 Static gobo wheel

This wheel has 5 metal gobos + open position, all gobos are interchangeable. Gobo wheel rotation from slow to
fast can be also adjusted.

6.5 Rotating gobo wheel

2 metal gobos, 1 glass gobo and 1 dichroic gobo rotating in both directions, indexable.

6.6 Iris

Motorized iris for different beam diameters

6.7 Effect wheel

3-facet prism, 5-facet prism and 5-linear facet prism rotating in both directions at different speed are situated at
the special effect wheel. Also wash light is provided by the special effect wheel.

6.8 Focus - multistep zoom

Motorized focus enables the beam to be focused anywhere on stage at different beam angles: 15°, 21°, 28°,
provided by the special multistep zoom (3 steps).

6.9 Dimmer / Shutter / Strobe

Smooth 0 - 100 % dimming is provided by the combined mechanical dimmer / shutter unit. This unit may also be
used for strobe effect (1 - 10 flashes per second)

6. Remotely Controllable Functions

29