Warning - PR Elecronics 5116 Handbuch

This module is designed for connection to hazardous electric
voltages.
Ignoring this warning can result in severe personal injury or
mechanical damage.
To avoid the risk of electric shock and fire, the safety
GENERAl
instructions of this manual must be observed and the guidelines
fol lowed. The specifications must not be exceeded, and the
module must only be applied as described in the following.
Prior to the commissioning of the module, this manual must be
examined carefully.
Only qualified personnel (technicians) should install this module.
If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired.
Until the module is fixed, do not connect hazardous voltages to
the module.
The following operations should only be carried out on a
hAZARD -
disconnected module and under ESD safe conditions:
OUS
vOlTAGE
Repair of the module and replacement of circuit breakers
must be done by PR electronics A/S only.
To keep the safety distances, the relay contacts on the module
must not be connected to both hazardous and non-hazard ous
volt ages at the same time.
SYSTEM 5000 must be mounted on a DIN rail according to DIN
INSTAl-
46277.
lATION
The communication connector of SYSTEM 5000 is connected
to the input terminals on which dangerous voltages can occur,
and it must only be connected to the programming unit Loop
Link by way of the enclosed cable.
24
General mounting, connection and disconnection of wires.
Troubleshooting the module.

WARNING

WARNING
WARNING