Warning - PR Elecronics 5114 Bedienungsanleitung

This module is designed for connection to hazardous electric
voltages.
Ignoring this warning can result in severe personal injury or
mechanical damage.
To avoid the risk of electric shock and fire, the safety instructions
of this manual must be observed and the guidelines followed.
GENERAL
The specifications must not be exceeded, and the module must
only be applied as described in the following.
Prior to the commissioning of the module, this manual must be
examined carefully.
Only qualified personnel (technicians) should install this module.
If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may
be impaired.
Until the module is fixed, do not connect hazardous voltages to
the module.
The following operations should only be carried out on a
HAZARD-
disconnected module and under ESD safe conditions:
OUS
vOLT AGE
Repair of the module and replacement of circuit breakers
must be done by PR electronics A/S only.
SYSTEM 5000 must be mounted on DIN rail according to DIN
46277.
The communication connector of SYSTEM 5000 is connected to
INSTAL-
the input terminals on which dangerous voltages can occur, and
LATION
it must only be connected to the programming unit Loop Link by
way of the enclosed cable.
18
Dismantlement of the module for setting of DIP-switches
and jumpers.
General mounting, connection and disconnection of wires.
Troubleshooting the module.

WARNING

WARNING
WARNING