Troubleshooting - Sony LT10-105 Bedienungsanleitung

11. Troubleshooting

When the unit does not work properly, check the following before calling Sony Manufacturing Systems Corporation
Representative for service
The power cannot
be turned on.
is displayed (Alarm)
Channel display is
(Alarm)
Fifth digit is "F"
No counting
• Turn off the power switch and turn it on 1 minute later.
• Check the connection and continuity of the power cable.
• Check for the proper range of power voltage.
• Reset the unit after moving the measuring probe at least 1 mm.
• Has the measuring probe's cable been disconnected?
• Has the maximum acceleration for the measuring probe been exceeded?
• Perform resetting operation.
• First carry out the reset procedure.
• Was the measuring probe exchanged with the power on?
• Is the measuring unit's connector locked?
• Is the measuring probe's cable disconnected?
• Connect a correctly functioning measuring probe and reset.
• Is the preset value too large (Overflow)?
• Turn off the power switch and turn it on 5 seconds later.
79