Troubleshooting; On-Screen Messages - Sony SDM-S71R Bedienungsanleitung

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 18.
If OUT OF SCAN RANGE appears on the screen
This indicates that the input signal is not supported by the
monitor's specifications. Check the following items.
I NFORMA T I ON
OUT OF SCAN RANGE
x x . x k H z /
If "xx.x kHz/xx Hz" is displayed
This indicates that either the horizontal or vertical frequency
is not supported by the monitor's specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
If "RESOLUTION > XGA" is displayed (SDM-S51R)
This indicates that the resolution is not supported by the
monitor's specifications.
If "RESOLUTION > SXGA" is displayed (SDM-S71R/
S81R)
This indicates that the resolution is not supported by the
monitor's specifications.
If NO INPUT SIGNAL appears on the screen
This indicates that no signal is input.
I NFORMA T I ON
NO I NPUT S I GNA L
GO TO POWER SAVE
GO TO POWER SAVE
The monitor will enter the power saving mode after about 5
seconds from the message is displayed.
Downloaded from: https://www.usersmanualguide.com/
x x H z
If CABLE DISCONNECTED appears on the screen
This indicates that the video signal cable has been disconnected
from the currently selected connector.
I NFORMA T I ON
CAB L E D I SCONNECT ED
GO TO POWER SAVE
GO TO POWER SAVE
The monitor will enter the power saving mode after about 5
seconds from the message is displayed.
GB
17