Canadian Department Of Communications; Ic Cs-03 Requirements - HP mfp analog fax Handbuch

Canadian Department of Communications

Users should not attempt to make such connections themselves, but
CAUTION
should contact the appropriate electric inspection authority, or
electrician, as appropriate. The Ringer Equivalence Number (REN) of
this device is 1.0.
44 Specifications and regulatory information
This equipment complies with Canadian EMC Class A requirements.
Conforme á la classe A des normes canadiennes de compatibilité
électromagnétiques. <<CEM>>

IC CS-03 Requirements

NOTICE: The Industry Canada label provided on the PCMCIA modem
card within the product, identifies certified equipment. This certification
means the equipment meets certain telecommunication network
protective, operational, and safety requirements as predescribed in the
appropriate terminal Equipment Technical Requirement document(s).
The Department does not guarantee the equipment will operate to the
user's satisfaction. Before installing this equipment, users should ensure
that it is permissible for the equipment to be connected to the facilities of
the local telecommunications company. The equipment must also be
installed using an acceptable method of connection. The customer
should be aware that compliance with the above conditions may not
prevent degradation of service in some situations. Repairs to certified
equipment should be coordinated by a representative designated by the
supplier. Any repairs or alterations made by the user or to this
equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect
the equipment. Users should ensure for their own protection that the
electrical ground connections of the power utility, telephone lines, and
internal metallic water pipe system, if present, are connected together.
The precaution can be particularly important in rural areas.
Notice: The Ringer Equivalence Number (REN) assigned to each
terminal device provides an identification of the maximum number of
terminals allowed to be connected to a telephone interface. The
termination of an interface may consist of any combination of devices
subject only to the requirement that this sum of Ringer Equivalence
Number of all the devices does not exceed five (5.0). The standard
connecting arrangement code (telephone jack type) for equipment with
direct connections to the telephone network is CA11A.
ENWW