Enabling Billing Codes; To Enable Billing Codes; Blocking Incoming Faxes; To Block Incoming Faxes - HP mfp analog fax Handbuch

Enabling billing codes

Note

Blocking incoming faxes

ENWW
You can use billing codes to track faxes for different departments. By
default, the billing-code feature is turned off.

To enable billing codes

1 On the control panel, press the menu button to access the main
menu.
2 Select CONFIGURE DEVICE.
3 Select the FAX menu.
4 Select FAX SEND.
5 Select BILLING CODES.
6 Select ON or OFF. When turning Billing Codes on, you also need to
select the number of digits for the code (up to 16).
Once you have enabled billing codes, you will be prompted to enter a billing
code each time you send a fax.
You can create a list of fax numbers to block. After you add a number to
the list, you will no longer receive any faxes from the blocked number.

To block incoming faxes

1 On the control panel, press the menu button to access the main
menu.
2 Select CONFIGURE DEVICE.
3 Select the FAX menu.
4 Select FAX RECEIVE.
5 Select BLOCKED FAX LIST.
6 To add a new number, select ADD ENTRY. To delete a number from
the list, select DELETE ENTRY. To completely clear the blocked
faxes list, select CLEAR ALL.
Enabling billing codes 25