Sulky Attachment; Maintenance, Servicing And Storage; Travelling Wheels; Tyre Pressure - Vari BDR-1200 Bedienungsanleitung

3. The cut stand would not pass through the discs and under the machine (because the stand is too thick).
➢ Use lower travel speed and reduce the cutting width.

2.4.4.4 Sulky attachment

Sulky is attached to the hitch in the rear bumper using a pin which is secured with a safety cotter. Sulky can only be used on flat surfaces with
minimum undulations. The double-drum mower and sulky set is able to operate on slopes of max. gradient of 10°.

2.5 Maintenance, servicing and storage


The weight of the cutter requires two persons for carrying out its maintenance and adjustment.
In order to be happy with our product in the long term, it is necessary to give it adequate maintenance and servicing care. Regular maintenance
reduces deterioration and ensures proper functioning of all its components.
Follow all instructions concerning maintenance and adjustment schedule. It is recommended that you keep a record of the number of its working
hours and conditions (for service needs). It is recommended to let one of our authorised service centres take care of the after-season maintenance, as well
as regular maintenance if you are not sure about your technical skills.

Check the nuts tightening the upper disc blades, and nuts tightening the lower disc to the flange before each cutter use.

2.5.1 Travelling wheels

Travelling wheels create an important part of the cutter. Wheels carry the whole weight of the cutter, transfer engine power, and push the cutter into
mesh.

2.5.1.1 Tyre pressure

Tyre pressure has to be controlled in order to secure proper functioning and long life of the wheels, especially the tyres. Check the pressure before
you start using the cutter. Fill the pressure to MAX before shutting the cutter down for a longer period of time. Keep equal pressure in right and left
wheels - it helps the mower to keep a straight track.
 Do not exceed the maximum tyre pressure – you risk a tyre explosion!
➢ MAXimum (recommended) tyre pressure: 150 kPa (21,8 PSI or 1,48 atm )
➢ MINimum 50 allowed tyre pressure: 120 kPa (17,4 PSI or 1,184 atm )
In case of permanent tyre pressure release, check and repair possible tyre defect.
 With regard to use of tubeless, always let a professional tyre-service to take charge of the repair.

2.5.2 Machine lubrication


Follow basic hygienic rules, and environmental laws when working with lubricants.
 Seek authorised service in case you lack appropriate manual skills
Smooth and easy movement of all mechanical parts requires adequate lubrication. Several drops of oil are usually sufficient (e.g. oil for bikes).
Transmission boxes are charged with sufficient amount of oil during manufacturing, and it does not require filling during the whole machine life.

2.5.2.1 Engine oil exchange

Follow the engine user manual instructions. If you use the cutter in a dusty environment, shorten the exchange period by half.
 Seek authorised service in case you lack appropriate manual skills.

2.5.2.2 Lubricating points

There is no need to dismount any cover from the machine when lubricating the cables on the handlebars. You can reach other lubricating points after
dismounting the covers. You can use any kind of engine, transmission or spray oil. Any kind of grease lubricant (multipurpose grease) designed for water
pumps is fully sufficient. For its application, however, it is usually necessary to dismantle the appropriate friction bearing.
Note: When using graphite grease, the seasonal lubrication intervals can be extended up to 25 hours.
50 If the pressure in tyres is lower than the minimum, the tyre gets damaged, thus reducing its service life significantly.
BDR-1200
25