Before Use; Mounting / Replacing Saw Blades; Rotating The Hand Grip; Adjusting The Shoe - Parkside PFS 710 A1 Betriebsanleitung

Before use / Preparing for use
©

Before use

©
Mounting / replacing
saw blades
Pull the mains plug out of the
WARNING!
mains socket before you carry out any task on the
device. Failure to observe this advice may lead to
injury.
Turn the quick-release chuck
the turned position.
Press the selected saw blade up to the stop
into the quick-release chuck
should engage.
Release the quick-release chuck
must then return to its original position. The saw
blade is now locked in place.
©

Rotating the hand grip

DANGER OF INJURY! Pull
WARNING!
the mains plug out of the socket before you carry
out any task on the device, The hand grip
be rotated by 90° to the right or left. This allows
the ON / OFF switch
3
comfortable position for any working conditions.
Press the unlocking button
hand grip to the right or left.
4
Make sure the hand grip
©

Adjusting the shoe

DANGER OF INJURY! Pull
WARNING!
the mains plug out of the socket before you carry
out any task on the device,
Adjust the shoe
5
To do this release the shoe adjustment lever
and place the shoe
Lock the shoe in this position by pulling the
shoe adjustment lever
10 GB/IE
and hold it in
7
. The saw blade
7
. The chuck
7
can
4
to be brought into the most
and rotate the
10
engages.
4
to suit the cutting depth.
in appropriate position.
5
tight.
8
©

Setting the blade speed

The desired blade oscillation speed can be prese-
lected by using the setting wheel
oscillation speed, MAX. = highest oscillation speed).
The blade speed can also be selected whilst you
are using the device.
©

Preparing for use

©
Switching on and off
When operating the device you can select between
intermittent or continuous operation mode.
To switch on intermittent operation mode:
Press the ON / OFF switch
To switch off intermittent operation mode:
Release the ON / OFF switch
To switch on continuous operation mode:
Press the ON / OFF switch
pressed position with the lock button
To switch off continuous operation mode:
Press the ON / OFF switch
again.
©
Guiding the sabre saw
safely and accurately
The shoe pivots to adjust to the workpiece and
5
8
provides safe support to the device. It must always
lie against the workpiece when the device is in use.
©
Advice about ways of
working when sawing
½
Before sawing, check the workpiece for foreign
bodies such as nails, screws etc. and remove them.
1 (MIN. = lowest
.
3
3 .
3 and fix it in the
.
2
and release it
3