Before Use; Change Sanding Sheets; Fitting/Changing Accessory Tools (Fig. A) - Parkside PWBS 180 B2 Originalbetriebsanleitung

Before use

WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
CAUTION!
► Wear protective gloves when changing
tools. There is a risk of injury if the accessory
tools are touched.
■ Different application tools are available,
depending on the material being machined and
the desired degree of surface removal required.
NOTE
► Do not put the appliance down without the
accessory tool fitted (sanding disc, carbide
sanding head, etc.). The brush ring
bend and be damaged.

Change sanding sheets

The surface of the sanding disc
a velcro fabric so that you can fasten sanding
sheets quickly and easily.
♦ Before attaching a new sanding sheet
remove dirt and dust from grinding disc
with a brush.
♦ Position the sanding sheet
edge of the sanding disc
sheet then onto the sanding disc
press it firmly into place. Make sure that the
suction holes on the sanding sheet
grinding disc match up.
♦ To remove the sanding sheet
and pull it off the sanding disc
PWBS 180 B2
may
consists of
,
, e.g.
flush against the
; lay the sanding
and
and the
, lift the edge
.
Fitting/changing accessory tools
(Fig. A)
WARNING!
► Press the spindle locking button
when the grinding spindle
Otherwise the appliance may be damaged.
NOTE
■ The carbide grinding head
removing formwork transitions on exposed
concrete, residual concrete on formwork
boards or adhesive residues on tiles.
■ Only use carbide sanding
heads
surface.
♦ Clean the sanding spindle
be mounted.
♦ Press the spindle locking button
and release the accessory tool.
♦ To fit the accessory tool, place the mounting
flange onto the sanding spindle
♦ Place the desired accessory tool onto the
sanding spindle
♦ Screw the clamping nut
the two-hole assembly spanner
NOTE
► Make sure that the collar of the clamping
nut is facing outwards.
only
is at a standstill.
is suitable for
with an even sanding
and all parts to
to clamp
.
.
and tighten it with
.
≤ 3,2 mm
GB │ MT │
41
12
■