Working Procedures; Before Use; Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level - Parkside PAMFW 20-Li A1 Originalbetriebsanleitung

Working procedures

Working principle
The oscillating drive causes the application tool to
move back and forth at a speed of 5000–19000
times per minute . This allows for precision work
even in confined spaces .
Sawing/cutting
■ Use only undamaged saw blades that are in
perfect working order . Bent, blunt or otherwise
damaged saw blades may break .
■ When sawing lightweight construction mate-
rials, follow the statutory regulations and all
recommendations from the material manufac-
turers .
■ Only soft materials such as wood, plasterboard
or similar should be processed using the plunge
saw process .
Sanding
■ To prolong the service life of the sanding
sheets , ensure that you apply even pressure .

Before use

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Push the battery pack
clicks into place .
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram) .
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PAMFW 20-Li A1
into the handle until it
and remove the
to
as follows:
Charging the battery pack
(see fig . A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level
is between 50% and 80% . The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C .
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket .
The control LED
♦ The green LED indicates that the charging
process is complete and the battery pack
ready .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
defective .
WARNING! RISK OF INJURY!
■ Always remove the battery before working on
the power tool .
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
to the high-speed
(see Fig . A) .
lights up red .
flashes, this means
has overheated and
both
into the appliance .
GB │ IE │ NI │
is
is
7 ■