Cleaning; Compressor; Care Of Tubes - Pari SINUS Bedienungsanleitung

7

Cleaning

7.1 Compressor

Before cleaning, turn the compressor off and remove the power cord from the
socket.
Do not pull the cable to remove the plug from the socket.
Figure C:
• Wipe the outer surface of your PARI SINUS compressor housing with a damp cloth.
Do not spray liquids into the ventilation slits. Such liquid may damage the elec-
trical equipment and other compressor parts and cause a malfunction.
If liquid gets into the compressor, please contact an authorised dealer or the PARI Serv-
ice Center (Tel.:+49-(0)8151-279 220 or info@pari.de). Do not use your PARI SINUS
compressor except on their instructions or after a check and any necessary repairs have
been performed by your authorised dealer or the technical Service Dept. of
PARI GmbH.

7.2 Care of tubes

Depending on the environmental conditions, condensation may occur in the pressure
hose and the bolus tube during usage. To ensure that treatment is carried out properly
condensation must be removed after use.
To do this proceed as follows:
• Detach the pressure hose (8) and the bolus tube (7) from the nebuliser.
• Leave the pressure hose inserted in the compressor (compressed air
connection (15)).
• Leave the compressor running until any condensation in the tubing has been removed
by the air-flow.
• Detach the pressure hose from the compressor.
• Now connect the bolus tube with the right end to the compressed air connection of the
compressor and proceed as described above until any condensation has also been
removed here.
Replace the PARI SINUS tube system (part. no. 041B4570) with every change of pa-
tient, or if the tube looks dirty.
20