Spare Parts; Cleaning; Safety Information; Procedure - SystemAir MUB 042 Montage- Und Betriebs-Anleitung

GB

12.4 Spare parts

♦ Use original spare parts from Systemair only.
♦ When ordering spare parts, please specify the serial number of the fan. This can be found on the name plate.
13

Cleaning

13.1 Safety information

♦ Cleaning may only be carried out by adequately qualified persons, details see Table 1 Qualifications, page 6.
♦ Wear protective equipment during all work in the vicinity of the fan, details see 2.2 Personal protective equipment,
page 6.
♦ Observe the 5 rules of electrical safety, see 2.3 5 rules of electrical safety, page 6.
♦ Ensure that the power supply has been switched off (all-pole circuit breaker).
♦ Ensure that the rotor is at a standstill.

13.2 Procedure

Important
Keeping the fan clean extends its service life.
♦ Install a filter monitor.
♦ Do not use steel brushes or sharp-edged objects.
♦ Do not use a high-pressure cleaner (steam jet cleaner) under any circumstances.
♦ Do not bend the fan blades when cleaning.
♦ When cleaning the rotor, pay attention to balance weights that have been positioned
♦ Keep the airways of the fan clear and clean them if necessary with a brush.
14

Deinstallation/dismantling

Deinstall and dismantle the fan in reverse order of installation and electrical connection.
15

Disposal

♦ Ensure material is recycled. Observe national regulations.
♦ The device and the transport packaging are predominantly made from recyclable raw materials.
♦ Disassemble the fan into its components.
♦ Separate the parts according to:
• reusable material
• material groups to be disposed of (metal, plastics, electrical parts, etc.)
| 001
25
Cleaning |