Setting A Tv - Yamaha DVX-1000 Bedienungsanleitung

■ Setting a TV

Notes
– Make sure you have completed all the necessary
connections (see "Connecting a TV" on page 14).
– To return to the previous menu, press .
– To exit from the menu, press SET UP.
– If the settings you have selected are not
appropriate, you can reset all settings to the initial
factory settings (see "Restoring to the factory
defaults" on page 43).
1 Press DVD/CD.
→
" " appears in the display panel.
DVD/CD
2 Turn on the TV and set to the correct video-in
channel.
→
You should see the background screen on the TV.
– Usually this channel is between the lowest and
highest channels and may be called FRONT, A/V IN
or VIDEO. See your TV manual for more details.
– Or, you may go to channel 1 on your TV, then press
the Channel down button repeatedly until you see the
Video In channel.
– Or, the TV remote control may have a button or
switch that chooses different video modes.
Selecting the TV type
In order for a DVD to play on this DVD receiver, the color
system of the DVD, the TV and the DVD receiver should
match. Before changing the TV system, determine the
color system of your TV.
1 In DVD/CD mode, press SET UP.
2 Press
/ repeatedly to select [VIDEO SETUP
PAGE].
3 Press
/
to highlight [TV TYPE], then press
.
VIDEO SETUP PAGE
TV TYPE
TV DISPLAY
PICTURE SETTING
ADV PICTURE
PROGRESSIVE
COMPONENT
PAL
NTSC
MULTI
4 Press
/ to highlight one of the options below:
PAL – Select this if the connected TV has the PAL
color system. It will change the video signal of an
NTSC disc and output it to PAL format.
NTSC – Select this if the connected TV has the NTSC
color system. It will change the video signal of a PAL
disc and output it to NTSC format.
MULTI – Select this if the connected TV is compatible
with both NTSC and PAL (multisystem). The output
format will be in accordance with the video signal of
the disc.
5 Select a setting and press ENTER.
– Follow the instructions shown on the TV to confirm
the selection (if any).
– If a blank/distorted TV screen appears, wait for 15
seconds for auto recovery to activate.
Selecting color system by using the
remote control
STANDBY/ON
DIMMER
BASS TREBLE
FREQ/TEXT
REPEAT
PTY SEEK
MODE
A-B
PRESET
ON SCREEN
ENTER
SET UP
AREA
DIRECT
MODE
ENHANCER
SURROUND DVD/CD
AUX TUNER
SUBTITLE ANGLE ZOOM
1 If a disc is inserted, press
2 Press
, then press AUDIO.
→
If the default setting of the color system is NTSC,
it will be changed to PAL.
→
If the default setting of the color system is PAL, it
will be changed to NTSC.
Getting started
EJECT
SLEEP
NIGHT
PROG
START
SHUFFLE
PRESET
MENU
TOP MENU
/RETURN
MUTE
USB
AUDIO
AUDIO
to eject the disc.
21
3
En