Use With An External Dmx Controller - Renkforce GM307 Bedienungsanleitung

Menu overview:
Display Setting
Addr A001-A512
CHnd 3CH / 5CH / 7CH
SLAU NO / YES
SOUn Sd-1 / Sd-2 / Sd-3
SP-1 to SP-8
JUNP JU01 to JU20
FL-0 to FL-4
FAdE Fd01 to Fd15
AUtO
COLO CL00 to CL11
FL00 to FL15
NAnU r000-r255
G000-G255
b000-b255
bLnd NO / YES
dISP NO / YES
b) Use with an external DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 3, 5 or 7 free DMX channels depending on operating mode.
Setting the DMX starting address
• Push the button MENU until "Addr" is displayed and push the button ENTER.
• Select the desired start address A001-A512 with the UP and DOWN buttons.
• Press the ENTER button to confirm your selection.
Function
DMX starting address
Number of DMX channels
Slave mode no/yes
Sound-to-Light mode 1 / 2 / 3 (3 different effects)
Sound-to-Light (microphone sensitivity low > high)
Colour change operation (change speed slow > fast)
Colour change operation (strobe speed slow > fast)
Fade operation(colour change slow > fast)
Automatic mode with changing effects
Static colours (12 colour settings)
Static colours (strobe speed slow > fast)
Manual colour setting brightness red off > full brightness
Manual colour setting brightness green off > full brightness
Manual colour setting brightness blue off > full brightness
Blackout Mode no/yes
Display alignment turned 0°/180°
33