Dmx-Controlled Operation; Addressing - EuroLite LED TMH-51 Bedienungsanleitung

DMX-controlled operation

You can control the projectors individually via your DMX-controller.
The device has three different DMX channel modes.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-51 Hypno Moving-Head Beam will respond to the controller.
If you set, for example, the address in the 21 channel mode to channel 50, the device will use the channels
50 to 70 for control.
To set the desired starting address press the MODE button until the display shows "Addr". Press ENTER to
confirm.
You can now set the desired address via the UP or DOWN buttons. Press ENTER once again to confirm.
Now you can start operating the LED TMH-51 Hypno Moving-Head Beam via your lighting controller.
To select the desired DMX Channel Mode (16CH / 21CH / 23CH) press the MODE button until the display
shows "Chnd". Press ENTER to confirm.
Choose the desired DMX Channel Mode via the UP/DOWN-buttons and again press ENTER to confirm.
Press the MODE button in order to return to the main menu.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-51 Hypno
Moving-Head Beam correctly and independently from any other fixture on the DMX-chain.
If several LED TMH-51 Hypno Moving-Head Beam devices are addressed similarly, they will work
synchronically.
The individual channels and their features are listed under DMX-protocol.
The SMD LED sections of the device are arranged in the following order (see graphic) and can be
individually controlled with the following DMX-protocol.
2
3
MODE UP DOWN ENTER
LED TMH-51
Hypno Moving-Head Beam
30/36
1
4
MIC
00110746, Version 1.1