Dmx-Protocol - EuroLite LED TMH-51 Bedienungsanleitung

Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received at the DMX-input, the a dot on the display will blink. If there is no data received at the DMX-input,
the dot will not blink.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are swap in the input connector.

DMX-protocol

The device has three different DMX channel modes. The Control Board allows you to assign the DMX
channel mode.
16 Channel Mode
Channel DMX Value
1 000 - 255
2 000 - 255
3 000 - 255
4 000 - 255
000 - 008
5
009 - 255
6 000 - 255
7 000 - 255
8 000 - 255
9
000 - 255
10 000 - 255
000 - 008
11
009 - 255
000 - 010
011 - 044
045 - 079
12
080 - 114
SMD
115 - 149
Section 1
150 - 184
185 - 219
220 - 255
000 - 010
011 - 044
045 - 079
13
080 - 114
SMD
115 - 149
Section 2
150 - 184
185 - 219
220 - 255
000 - 010
011 - 044
14
045 - 079
SMD
Section 3
080 - 114
115 - 149
Function
Pan 0°~ 540°
Tilt 0°~ 210°
Pan&Tilt Speed with decreasing speed
Master Dimmer 0%~ 100%
No function
LED Strobe with increasing speed
RED LED Dimmer 0%~ 100%
Green LED Dimmer 0%~ 100%
Blue LED Dimmer 0%~ 100%
White LED Dimmer 0%~ 100%
SMD Dimmer 0%~ 100%
No function
SMD Strobe with increasing speed
No Function
Red
Green
Blue
Red and Green
Red and Blue
Green and Blue
RGB
No Function
Red
Green
Blue
Red and Green
Red and Blue
Green and Blue
RGB
No Function
Red
Green
Blue
Red and Green
31/36 00110746, Version 1.1