Stand-Alone Operation; Control Board - EuroLite LED TMH-51 Bedienungsanleitung

Stand-alone operation

In the Stand-alone mode, the LED TMH-51 Hypno Moving-Head Beam can be used without controller.
Disconnect the LED TMH-51 Hypno Moving-Head Beam from the controller and call up the internal
programs. Please refer to the instructions under Control Board.

Control Board

The Control Board offers several features: you can easily set the starting address or run the pre-
programmed program.
Press MODE to access the menu on the display. Browse through the main menu by pressing UP or DOWN.
Press ENTER in order to select the desired menu. You can change the selection by pressing UP or DOWN.
Press ENTER in order to confirm. You can leave every mode by pressing MODE. The functions provided are
described in the following sections.
Menu
Addr
Chnd
Slnd
Shnd
Auto
Soun
Sens
Led
disp
Pan
Tilt
Test
Temp
hour
Ver
rset
Sub menu
001-512 DMX address setting
16Ch
21Ch
Setting DMX channel mode
23Ch
Mast Master-setting
SL1
Slave-setting
SL2
d512
When no DMX signal is received, no function: Blackout
Sh1
Sh2
Internal programs
Sh3
Sh4
Auto mode
Auto1
Auto2
Auto3
Auto4
SP0 – SP9 Speed (increasing)
On/Off Sound controlled mode
000~100 Microphone sensitivity (increasing)
on
LED on/off
off
on
Display reverse 180°
off
Yes
No
Reverse movement PAN/TILT
Yes
No
Function test
Temperature indication
Fixture running time
Software version
Reset
Function
29/36 00110746, Version 1.1