Master/Slave Operation; Connection With The Mains; Operation - EuroLite LED TMH-51 Bedienungsanleitung

Caution: At the last fixture, the DMX cable has to be terminated. Plug the terminator with a 120
between Signal (–) and Signal (+) in the DMX output of the last fixture.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
To set the Master/Slave mode, press the MODE button and select Slnd.
Set the master device to MASTER mode. You can now set the desired internal program or sound control.
To set the slave device, press the MODE button and choose SLAVE 1 or SLAVE 2. The devices set in this
manner can now be controlled by the master unit.
Please see further instructions under Control Board.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the LED TMH-51 Hypno Moving-Head Beam starts running.
During the Reset, the motors are trimmed and the device is ready for use afterwards.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the Control Board or in
DMX-controlled mode via any commercial DMX controller.
International
L
N
28/36
Ω resistor
00110746, Version 1.1