Operation; Adjust Telescopic Arm; Swivelling The Cutter Bar - FLORABEST FTHSA 20 B2 Originalbetriebsanleitung

1. Unpack the device and check
for completeness.
B
2. Slide the motor head (2) onto the
tubular shaft of the telescopic tube
(6). Slide the motor head (2) up
to the assembly stop (22) onto the
3. Secure the motor head (2) and the
telescopic tube (6) with the cap
5
nut (5) in the clockwise direction
motor head mounting (21) and
tighten the cap nut (5) by hand.

Operation

Do not use the equipment
without the hand guard.
Wear suitable clothing and
work gloves when working
with the equipment.
Ensure that the equipment
is functional before each
use. The On/Off switch and
the safety switch must not
be held closed. They must
switch off the motor when
on is released. Should a
switch be damaged, stop
working with the equipment.
Ensure that the mains volt-
age value matches the label
on the equipment.
Note noise protection and local
ment on certain days (e.g. Sundays
and national holidays), at certain
times of day (lunch times, night
time quiet periods) or in special ar-
eas (e.g. health resorts, clinics etc.)
is restricted or forbidden.
on to the thread of the

Adjust telescopic arm

continuously with the star wheel (7).
D 1.
2.
22

Swivelling the cutter bar

1.
E
2.
3.
-
G B
Loosen the star wheel (7).
Hold the device on the handle
(8) and on the telescopic tube
(6) and change the rod length
by pushing or pulling.
Hold the blade safety bar (1) on
the bottom of the motor head (2).
Press the release button (
Swivel the motor head (2) with
the blade safety bar (1) into the
desired angular position and re-
lease the release button (
2
possible positions.
are indicated on the
current latching step
is indicated by an
arrow.
I E N I
A
3).
A
3).
1 5